QT Big Button, Instruction Manual

Page: 5 / 14

4
GETTING STARTED
1. Insert one end of the line cord into the line jack marked “line” at the base of the phone and
the other end to the wall outlet from the telephone exchange or PABX.
2. Connect one end of the curly cord to the handset jack and the other end to the jack on the
side of the base of the telephone.
3. Once the telephone has been connected to the telephone exchange line the LCD will
display the date and time. For the backlight to function batteries (3x1.5V AA Alkaline) have
to be inserted or a power adaptor must be connected to the telephone.
4. Set the dialing mode to pulse or tone depending on the service provider’s requirement.
5. Apply for caller Identification service from your service provider
RECEIVING A CALL
1. On receipt of an incoming call the phone will ring and the LCD displays the caller’s number,
the date and time and the “NEW” icon.
2. If a call from the same number is received again, the LCD displays the “REP” icon.
When the incoming memory is full, the latest incoming number replaces the oldest number in
the memory.
NOTE: For the phone to display incoming numbers and other information, you must have an
active Caller ID subscription with your service provider.
¾
From the handset
1. Pick up the handset and talk to the other party.
2. To end a call, return the handset to the base.
3. The speaker button functions only as hands free dialing and monitoring, and is not a full
hands-free speaker feature. For two-way conversation the handset must be used.
NOTE:
1. The handset receiver is hearing-aid compatible.
2. To boost the handset speaker volume in the case of hearing impaired persons switch
the handset switch at the bottom of the phone to V.HI. In the case of normal hearing
do not use the V.HI (Booster Feature).
3. Generally the Caller Identification signal is transmitted by the Service Provider, between the
first and second ring, in this case answer an incoming call after the second ring to have the
CLI number displayed.