184050
Page 39
DCS Configuration
A Digital Cinema Server is normally configured to send commands to the JSD-60 over Ethernet
or RS-232 at appropriate times during content play out. The user needs to configure macros to
send commands to the JSD-60.
The automation commands for a JSD-100 are accepted and processed accordingly. Servers vary
in how control characters (such as tab and carriage return) are entered. The table below lists a
few servers and how control characters are entered. Consult the Knowledge Base on the USL
website for updates to this list.
DCS
Manufacturer
Control Code Entry
Dolby
Automation commands are currently only supported over RS-232, not
Ethernet. In Show Manager, on the "serial automation" system page, there
is a "termination" field where you can put byte codes to be added to the
end of each command. By default the system includes "\0A" (line feed) in
this field, but you can change it "\0D" (carriage return) or any other
sequence. This will terminate each automation string. To insert a tab in an
automation string, use “\09”.
Doremi
Use "\r" to send a carriage return at the end of a string defined for a raw
device. Use “\t” to inset a tab in an automation string. Use “\w” to insert a
short wait in a command.
Summary of Contents for USL JSD-60
Page 1: ...USL JSD 60 User Manual Cinema Processor...
Page 2: ...184050 Page 2...
Page 4: ...184050 Page 4...
Page 43: ...184050 Page 43...
