5
TD-000512-00-A
EN
Individual Transducer Connection (requires modification)
The transducers are wired in parallel inside the enclosure. If individual transducer
connection is required, remove the terminal cup and remove the yellow and the
blue jumper wires that are connected between the SPK1 and SPK2 terminals.
Replace the terminal cup and mark the enclosure with a note of the modification.
WAUNIRG!:
Requires removal of the terminal cup then cutting the
yellow and blue jumper wires connecting the SPK1 and SPK2 terminals
— Figure 4 —
*NOTE
SPEAKERS INTERNALLY CONNECTED IN PARALLEL FOR
INDIVIDUAL CONNECTION: REMOVE PANEL, CUT YELLOW
AND BLUE JUMPER WIRES.
(For insturctions see User Manual)
INPUT/SPK1*
SPK2*
SB-2180 Specifications
Frequency Range
1
(-10 dB)
25 Hz to 150 Hz
Rated Noise Power
2
1100 W
Sensitivity
3
100 dB
Maximum continuous SPL
4
130.4 dB
Maximum peak SPL
4
136.4 dB
Impedance
4
Ω
Recommended Amplifier Power
2200 W
Transducer
Two 18 in. (457 mm) woofers, 4 in. voice coils
Enclosure Details
Input Connector
4-position barrier strip
Enclosure Material
MDF, 19 mm
Grille
None
Dimensions (HxWxD)
33.15 x 42.5 x 16.5 inches (842 x 1080 x 420 mm)
Net Weight
187 lb (89 kg)
1
Half-space (2 pi), unprocessed, -10 dB from on-axis sensitivity
2
AES2-1984 noise signal for 2 hours
3
On-Axis, free-field sensitivity, 2.83 V, 1 m
4
Calculated from rated noise voltage and sensitivity
RIUE!:
Specifications subject to change without notice.
