EN
19
Getting Started (continued)
17-
Select Device, Add New Device, from the menu. A new window will open prompting you to name the device. Name it logically,
such as BASIS 1, or similar. Select the Device Type and select BASIS 922az. At the Password prompt, enter “qsc” (lower case, no quo-
tation marks). This is the device password, separate from the software password. The default, in both cases, is “qsc”, but you are free
to change either or both. Enter the IP address of the BASIS and click OK.
18-
The BASIS will now appear in the inventory root (left side of screen). If the BASIS does not show in the inventory root, check that a
crossover cable is used (only for BASIS connected directly to PC), check the cable connections, verify IP addresses are set correctly, ver-
ify Subnet masks are set correctly, and verify AC power is properly applied to the BASIS.
19-
Click on the BASIS 922az in the inventory root. A view of applicable device tabs will open. Click the DSP tab and the current DSP
configuration of the BASIS will be displayed. Default DSP routing is Analog Inputs 1-8 are routed to DataPorts 1-4, with each DataPort
assigned 2 sequential channels (i.e. Analog Inputs 1 and 2 are routed to DataPort A, Inputs 3 and 4 are routed to DataPort B, etc....).
20-
Right click on the Design Editor icon in the lower left of your display; select “New”. A new window opens; select BASIS 922az for
the device type.
21-
Click on Help to access the software’s Help system. All software operation is covered in the on-line help file.
Operation of the BASIS 922az is accomplished with the included QSControl.net software. No soft-
ware operation is covered in this hardware manual. After installing your software, open the Help file
and follow its recommendations. The software Help file includes the most recent information avail-
able for your BASIS 922az.
Summary of Contents for BASIS 922az
Page 26: ...Notes...
Page 27: ...Notes...
