Page 6 of 34
QSA Global, Inc.
40 North Avenue Burlington, MA 01803
888.272.2242
781.272.2000
F: 781.359.9179
qsa-global.com
SAFETY PRECAUTIONS
.
WARNING
Do not perform any unauthorized modifications to the OpenVision™ system or its components.
It is important that trained and qualified personnel perform or supervise a daily safety inspection of the
OpenVision system for any defects. Do not compromise on safety. Always perform daily system inspections
prior to use.
Any foreign material (dirt, mud, ice, etc.) must be removed before using the system. Inspect, clean, and test the
equipment as described in this manual to ensure long-term safety and reliability.
Do not use any component that is not approved for use with the OpenVision system or any after-market
component. Doing so may compromise the safety features designed into the system.
Defective equipment that is discovered during daily inspections must be removed from service until repaired or
replaced.
Equipment operators must follow all operating instructions, in the order shown, to ensure safe operations and
compliance with government regulations.
Personnel operating this equipment must be completely familiar with this manual and they must read and understand
these important safety alerts before proceeding:
IMPORTANT SAFETY ALERTS
NOTICE
: Can cause minor problems and reminders.
CAUTION
: Can cause equipment damage or potential problems.
WARNING
: Can cause serious or fatal injury.
WARNING: JOB SITE SAFETY PRECAUTIONS
Surveillance
Only trained and qualified individuals, or assistants working under their direct supervision, may operate the
OpenVision DX system. The qualified individuals must be physically present at the site and able to control and
limit access to the vicinity of the work.
Locking
Keep the OpenVision DX controller locked while assembling the system and when not being used to perform
scanning. Locked is defined as the controller key switch in the Off position with the key removed. Store the key in
a secure location.
