Page 3 of 10
ds1_antenna_assy_072920.pdf
You will start with the loading coil first.
[ ]
Thread the 4mm x 16mm long screw, and #8 lock washer into one of the PEX plugs from the
inside. Hold the brass PEX plug where shown below with pliers and tightly secure the screw.
[ ]
Slide the piece of PEX tubing into the copper pipe plug all the way to the bottom and tape with
scotch tape to prevent it from rotating. Place the PEX plug from the operation above into the
open end of the PEX pipe.
[ ]
Mark places for the holes in a straight line as shown below and drill Ø5/64” holes thru to the
inside only. The 11/16” location will go thru the copper and PEX tubing, the 2 3/4” location thru
the PEX tubing and PEX brass plug..
