Page 10 of 10
ds1_antenna_assy_072920.pdf
[ ]
Again, remove the enamel insulation from the wire where the wire wraps around the screw and
secure this end with the 4-40 screw as shown below.
[ ]
The coil gets covered with clear heatshrink tubing. Center the sleeve and shrink it to the
assembly.
This completes the assembly.
For 40m this coil is installed between the antenna whip and the existing loading coil.
Notes:
_____________________________________________
_____________________________________________
_____________________________________________
_____________________________________________
_____________________________________________
_____________________________________________
_____________________________________________
