QOMOTOP TGG02T, User Manual

Page: 8 / 16

WARNINGS: LP TANK
INSTRUCTIONS FOR LIGHTING BURNER:
OPERATING INSTRUCTIONS
1. Read all instructions before lighting.
2. Make sure all control knobs are in the OFF position.
3. When use 20lb. cylinder: Turn on the cylinder valve.
4. Select the burner to be lit. Push and turn the control knob
of that burner counter-clockwise to HIGH. Hold the control
knob pushed down for 2-3 seconds. It will light the burner.
5. Adjust the flame by turning control knob between HIGH and LOW.
6. Repeat step 4 for lighting other burner.
7. If ignition does not occur in 5 seconds, turn the burner control(s) OFF, wait 5 minutes, and repeat
the lighting procedure.
MANUAL LIGHTING
1. Make sure all control knobs are in the OFF position.
2. When use 20lb. cylinder: Turn on the cylinder valve.
3. Remove the cooking plate. Insert a match into the match lighter.
Strike the match and place near the gas outlet openings on the
burner. Push and turn the control knob of that burner
counter-clockwise to HIGH. Hold the control knob pushed down for
2-3 seconds. It will light the burner.
4. Adjust the flame by turning control knob between HIGH and LOW.
5. Repeat step 3 for lighting other burner.
6. If ignition does not occur in 5 seconds, turn the burner control(s)
OFF, wait 5 minutes, and repeat the lighting procedure.
7. Place the cooking plate back onto the griddle body.
Note: Match lighter is attached to the main valve tube at the bottom of gas griddle.
by the manufacturer. Place the match lighter on the platform of the control panel after use.
SHUT DOWN INSTRUCTIONS
2. 20LB. cylinder: Turn LP cylinder gas valve clockwise to OFF position when griddle is not in use.
1LB cylinder: Turn the cylinder counter-clockwise to disconnect cylinder from regulator when
griddle is not in use.
1. Push and turn control knob clockwise to OFF position.
WHEN THE BURNER FLAME IS ACCIDENTALLY EXTINGUISHED
1. Close the LP tank valve.
2. Push and turn control knob clockwise to OFF position.
3. Inspect if the hose etc. connections are good, wait 5 minutes. After waiting 5 minutes, re-start the
appliance following the lighting instructions.
REGULATOR HOSE ASSEMBLY CHECK:
WARNING
Before each use, check to see if there is evidence of abrasion, wear, cuts or leaks on the hose. If
damage is evident, the hose must be replaced prior to appliance use.
DISCONNECTING HOSE ASSEMBLY FROM 20LB. CYLINDER:
1. Turn control knob to the OFF position.
2. Turn the cylinder valve off fully (turn clockwise to stop).
Detach the hose assembly from the cylinder valve
by turning the quick coupling nut counterclockwise.
DISCONNECTING REGULATOR ASSEMBLY FROM 1LB CYLINDER
1. Turn control knob to the OFF position.
2. Turn the cylinder counter-clockwise to disconnect cylinder
from regulator assembly.
NOTE: Loosen by hand only. DO NOT use tools.
8
Shut off gas supply by rotating valve of gas cylinder clockwise.
Gas cylinder
Detach hose assembly
by rotating it
counterclockwise