Plug in the AC input cord to the wall outlet. For the best results, suggest charging the battery at least 8 hours
before initial use.
The unit charges its battery while connecting to the utility.
Plug in the loads to the output receptacles on the rear panel of the UPS. Simply turn on the power switch of UPS
unit, then devices connected to the UPS will be protected by UPS.
CAUTION: Only bypass output can connect a laser printer or scanner. Otherwise, it may cause the damage of the unit.
2 independent USB ports (5V, 2A) are used for convenient charging without the help of external devices.
Turn on the UPS by pressing the power switch. Turn off the UPS by pressing again the power switch.
When the UPS is off and there is no
power utility, it’s still possible to
use cold start the UPS unit to power the
loads.
When AC fails, and the battery supplies power to the device, UPS will alarm once every 6 seconds and the beep
stops about 40 seconds later.
When the battery is nearly used up, the UPS will alarm automatically and the beep frequency is once 2 seconds.
When the battery is really used up, the UPS will alarm for a very long time and turn off automatically.
When UPS is in the battery mode and there is no shock or short-circuit, UPS will emit a limited amount of current to
protect itself. (In mains mode, the UPS will be protected by input fuse firstly and then transfer to the battery mode.)
