5.
Attach the case cover.
Note
.
6.
Power on the device.
7.
Verify that the module is recognized by the device.
a.
Log on to QTS as administrator.
b.
Go to
Control Panel
>
System
>
System Status
>
Hardware Information
.
c.
Check the value for
Total memory
.
Connecting the Switch to a Computer or Network
The QGD-3014-16PT can be connected to a computer or local area network. For details, see the following
topics:
•
Connecting the Switch to a Computer
•
Connecting the Switch to a Network
Connecting the Switch to a Computer
Connecting the QGD-3014-16PT to a QNAP NAS allows you to expand storage capacity and backup data to
another NAS through Ethernet cable connections to a PoE port on the switch. However, you must connect
the QGD-3014-16PT to a computer to configure switch settings.
1.
Power on the switch.
2.
Connect the switch to a computer.
a.
Connect an Ethernet cable to a PoE port on the switch.
b.
Connect the Ethernet cable to a Gigabit Ethernet port on the computer.
QGD-3014-16PT User Guide
Installation and Configuration
31
