Take out the AA
，
installation
requires two people
AA
5 of 8
Install
to Solid Concrete or Cinder Block
Use wall plate of (
AA
) as template to mark mounting holes.
Drill four 3/8" (10 mm) dia. holes 2.5" (65 mm) deep.
Insert concrete anchor (
H
secure with
M8x 63.5 screws (
G
) and Washer 2 (
G
). Level, then tighten
all fasteners.
•
When installing the wall mount to cinder block, verify that you have a minimum of 1-3/8" of actual solid concrete
thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid
part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifications.
It is recommended that a standard electric drill set on a slow setting is used to drill the hole instead of a hammer
drill to avoid breaking out the back of the hole when entering a void or cavity.
•
Concrete must have a 2000 psi density minimum. Lighter density concrete may not hold the concrete anchor.
•
Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
WARNING
A
CU
TA
W
AY
V
IE
W
INCORRECT
CORRECT
wall plate
plaster/
dry wall
concrete
wall plate
concrete
plaster/
dry wall
•
Always attach concrete anchors directl to load-
bearing concrete.
•
Never attach concrete anchors to concrete covered
with plaster, drywall, or other finishing material. If
mounting to concrete surfaces covered with a finishing
surface is unavoidable, the finishing surface must be
counterbored as shown below. Be sure concrete
anchors do not pull away from concrete when tighten-
ing screws. If plaster/drywall is thicker than 5/8",
custom fasteners must be supplied by the installer.
WARNING
y
•
Tighten screws so that wall plate is firmly attached,
but do not overti hten. Overtightening can damage
screws, greatly reducing their holding power.
WARNING
g
concrete
surface
1
3
2
H
Drill holes and insert anchors (
H
).
Place wall plate of
(
AA
)
over anchors (
H
) and secure with (
G
).
Tighten all fasteners.
H
G
solid concrete
cinder block
G
AA
H
A
10mm(3/8”)
masony bit
