*
()
®
®
/�!.&1$
Refer to the
instructions in
chapter 3
(parallel) or
chapter 4
(Ethernet) of the
Getting Started
manual to
connect your
printer to a PC
or network.
Make sure the
printer is turned
off.
Plug the printer
into a grounded,
surge-protected
electrical outlet.
Turn on the
printer. A startup
page should
print when the
printer is
powered on.
2&0 !
See the
Getting
Started
manual
for instructions
on installing the
QMS printer
driver.
Use the on-line
help to configure
the driver for
printing.
See the
Reference
manual for
complete
instructions on
configuring the
printer through
the control panel
menus.
!
+
Refer to one of the following:
• Chapter 8, “Troubleshooting Printer Problems,” in the QMS
magicolor 2
Print System Operation
manual.
»
Note: The Operation manual is on the Documentation CD-ROM.
• Appendix A, “QMS Customer Support,” in any QMS
magicolor
2 Print
System manual.
&
• Operate the printer within a temperature range of 50°–90.5° F (10°–32.5° C) and a relative humidity range of 20%–80%.
• Install the printer on a hard, level surface capable of supporting about 100 lbs (45.4 kg). The printer must be placed within 1.5° of level.
• Allow enough space around the printer to allow adequate ventilation and easy servicing.
• Use a properly grounded AC outlet with a line voltage of 100 V, 120 V, or 220–240 V, ±10%.
• Maximum electrical current required during operation is 10 amps for a 100 V system, 8.3 amps for 120 V, and 4 amps for 220–240 V.
• Recommended frequency is 50–60 Hz ±2 Hz for a 100 V system, 60 Hz ±2 Hz for a 120 V system, and 50 Hz ±2 Hz for a 220–240 V system.
#$
(#
Installation
Operator
Administration
Idle
Operator
Use Operator
Admin
Use Admin
(Enter
Off, On
(Enter
Off, On
Internet—Visit the QMS Product Registration page on the
Internet at http://www.qms.com/support/prodreg/
Mail—Fill out and send in the warranty card enclosed in your
shipment.
Telephone—In the US, call QMS toll-free at 1 (800) 637-8049.
