QMS 1800409-001A, User Manual

Page: 282 / 436

record of your changes before you go to the next step. See
chapter 4, “Printer Configuration,” for information on
using the configuration menu.
10. In the printer configuration menu, use the Administration/
Miscellaneous/Restore Defaults option to make the printer
recognize the additional memory.
The Administration/Memory section in chapter 4, “Printer
Configuration,” and Appendix D, “Additional Technical
Information,” contain information about printer memory.
Installing a Network Interface
This section describes how to install a network interface.
NOTE: The QMS magicolor LX printer is compatible only
magicolor LX network interfaces. If a non-magicolor LX
interface is installed, the following error message appears
on the start-up page: “Incompatible network option
installed.” Also, depending on which type of interface
you are installing, the interface card in the illustrations
accompanying these instructions may look slightly
different from your interface card, but the installation
procedure is the same.
Make sure you have all the parts necessary for the interface
installation. The network interface kit includes the following:
■ An anti-static wristband
■ A network interface card and two plastic support posts
■ A daughterboard and two plastic support posts
Chapter 8
8 - 2 6 P r i n t e r O p t i o n s