QMAXZ Lighting QS Series, User Manual

Page: 6 / 36

QS series manual v3.09 QMAXZ © 2009 - 5 -
Requirements for the rigging place:
When mounting the fixture vertically the P/T speed must be set to speed 6 in the fixture menu
(default value).
•
For safety the fixture should have a secondary fixing with a safety cord through the truss and
the handle of fixture. The safety cord must bear at least 10 times the weight of the fixture.
•
When rigging, de-rigging or servicing the fixture make sure that no people are staying in the
area below the fixture and other endangered areas.
•
Check that the tilt lock is released.
•
Verify that there are no combustible materials or surfaces to be illuminated within 2 meters (78
inches) of the fixture and that there are no flammable materials nearby.
•
Check that there is no possibility of heads or yokes colliding with other fixtures.
•
If any accidents happen due to not following the above instructions, the manufacturer will not
be responsible for it.
5.
LAMP REPLACEMENT
Installing any other lamp then advised by the manufacturer may create a safety hazard or
damage the fixture!
Model Philips
QS250S MSD 250/2, GY9,5
QS250W MSD 250/2, GY9,5
QMAXZ fixtures are tested with PHILIPS bulbs. QMAXZ also advises to use the same bulbs for
replacement. QMAXZ is not responsible for any damage to the fixture when using other bulbs!