Qlogic QLA200 HBA, User Manual, Page: 34 / 54

5 – NetWare Driver Installation
Installing the Driver
5-2 FL0054601-00 B
5.3
Installing the Driver
This section describes four NetWare driver installation options:
■
Installing the driver during installation of the NetWare operating system (see
section 5.3.1)
■
Installing the driver on an existing NetWare server (see section 5.3.2)
■
Updating the existing driver on a NetWare server (see section 5.3.3)
5.3.1
Installing the Driver During Installation of the NetWare Operating System
Perform the following steps to initially install the NetWare OS and the NetWare
driver:
Step 1. If you have not already done so, install the QLA200 HBA (see section 2) .
Step 2. Insert the driver disk (created in section 5.2 ) and the NetWare OS install
CD into the NetWare server. Power up the server.
Step 3. Follow the standard NetWare instructions to begin the installation.
Step 4. Do one of the following:
If the server will be booting from a device attached to the QLA200 HBA,
perform the following steps to enable the BIOS and specify the boot device:
a. Start Fast! UTIl (see section 7.1) .
b. Enable the BIOS (see section 7.2.1) .
c. Specify the boot device (see section 7.2.2) .
d. Exit Fast! UTIL.
If the server is booting from a device that is not attached to the QLA200
HBA, perform the following steps to disable the BIOS:
a. Start Fast! UTIl (see section 7.1) .
b. Disable the BIOS (see section 7.2.1) .
c. Exit Fast! UTIL.
Step 5. After the Netware OS installation is complete, restart the server.