5 – NetWare Driver Installation
Installing the Driver
FL0054601-00 B
5-3
5.3.2
Installing the Driver on an Existing NetWare Server
Perform the following steps to add the NetWare driver to the existing NetWare
system:
Step 1.
If you have not already done so, install the QLA200 HBA
Step 2.
Insert the driver disk (created in
) into the NetWare server.
Power up the server.
The HWDETECT or NWCONFIG program automatically detects the
QLA200 HBA, and locates and loads the driver. If the programs do not find
the driver (the QL2300.HAM file is missing from the
Storage adapters:
field of the drivers page), follow the instructions in
to manually
install the driver files.
5.3.3
Updating the Existing Driver on a NetWare Server
The HWDETECT or NWCONFIG program should find and prompt you to install the
updated driver. If the programs do not find the driver (the QL2300.HAM file is missing
from the
Storage adapters:
field of the drivers page), perform the following steps
to manually install the driver files:
Step 1.
Insert the driver disk created in
Step 2.
Use either the NetWare Remote Manager or the DOS copy command to
copy the files from the driver disk to the NetWare server.
NetWare Remote Manager:
a. Start the NetWare Remote Manager from the NetWare GUI (execute
STARTX).
b. Copy the QL2300.HAM and QL2300.DDI files (drag and drop) from the
disk to the following directories on the server:
C:\NWSERVER\DRIVERS
(NetWare 6.
x
)
C:\NWSERVER
(NetWare 5.
x
)
DOS Copy Command:
a. Start at the DOS prompt. If your server does not stop at the DOS prompt,
press the F8 key when the
Starting DOS
or
Starting Caldera DR-DOS
message displays during a hardware boot. If you miss the message,
press CTRL+ALT+DELETE, then wait for the message to re-display.
