12
、
This Heater is hot when in use .To avoid burns, do not let b skin touch hot surfaces. Always use handle when
moving this heater, Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and
curtains at least 3 feet (0.9m) from the front of the Heater and keep at least 1foot (0.3m) from the sides and
rear.
13
、
A Heater has hot and arcing or sparking parts inside. It must NOT be in potentially dangerous locations such
as flammable explosive, chemical –laden or wet atmospheres, Heater is intended for general use only.
14
、
This Heater is not intended for use in wet or damp location. Never locate a Heater where it may fall into a
bathtub or other water container.
15
、
Do not use Heater outdoors.
DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING
WARNING
: To avoid danger of electrical shock, unplug from outlet when not in use and before cleaning .If the
supply cord is damaged, it must be replace by a special cord or assembly available from the manufacture or its
service agent.
SAVE THESE INSTRUCTION FOR FUTURE REFERENCE
The Heater may be operation by the manual soft controls located on the Heater (as shown in FIGURE1) or by your
remote control (shown in FIGURE3).
1.
Carefully remove the Heater from the plastic bag and the carton.
2.
Place the heater on a firm level surface.
3.
Set the main power to ‘ff’. Plug the cord set into a 220-240V ~A.C.electrical outlet. Turn the main POWER
switch to ‘ON ‘position .A ‘Beep’ sound and the red light will come on indicating that there is power to the
unit. The Heater is ready to use .The red light will remain lighted until the main POWER switch is turn OFF
and the Heater is unplugged from the electrical outlet.
4.
Turn the Heater ON by pressing the ON/OFF button
(FIGURE1). The unit will display the current
ROOM temperature, automatic into “FAN” mode, and blow the cold air.
5.
Upon turning the heater on, the unit will be in the low heat mode.
6.
Pressing the’ HEAT MODE’ button second time, the unit will set the Heater into high heat model.
7.
Pressing the’ HEAT MODE’ button once more will set the Heater into AUTO mode. Notice that the display
now displays a ‘SET TEMP indicator. (See Thermostat Instruction).
8.
To turn the heater OFF, press the ON/OFF button.
PARTS NAME
OPERATION
