ww w.qlight.com
PLAY MODE
1
Bit Input
Mode
5 sounds can be played from the selected group
(choose one group from six groups)
2
Binary Input
Mode
Up to 30 sounds available for each model. Plays
sound only once (sequential signal input only)
3
Bit Input
Hold
Playback
Mode
5 sounds can be played from the selected group
(choose one group from six groups)
The sound is repeated if the input signal is
maintained. (sequential signal input only)
If the STOP signal is inputted, the sound is
turned off, and if the STOP signal is disabled the
sound is played repeatedly
4
Binary Input
Hold
Playback
Mode
Up to 30 sounds available for each model
The sound is repeated if the input signal is
maintained. (sequential signal input only)
If the STOP signal is inputted, the sound is
turned off, and if the STOP signal is disabled the
sound is played repeatedly
5
Bit Input
Sound
Reduction
Mode
)
5 sounds can be played from the selected group
(choose one group from six groups)
You can reduce the volume(15dB) by using a
separate volume reduction signal line
(same as volume reduction signal input)
6
Binary Input
Sound
Reduction
Mode
Up to 30 sounds available for each model.
You can reduce the volume(15dB) by using a
separate volume reduction signal line
(same as volume reduction signal input).
7
Bit Input
Sequence
Memory Play
back Mode
5 sounds can be played from the selected group
(choose one group from six groups)
If the sound is inputted in a order, it will
remember the order and play each sound about
3 seconds .
The last input channel is fully played
(bit input mode only)
4
9. VOLUME CONTROL
- You can adjust the speakers sound output by using the volume dial.
VOLUME CONTROL
Volume
up
Volume
down
10. Insert flat-head driver into the hole. In case of turn right,
volumes up and turn left, volumes down. (Sound is disabled
once the dial turns right to MIN.)
Bit input type sound pattern group composition
Sound
CH
Sound Tone
WS
5 Warning
Sounds
CH1 Fire.A-ANG(560Hz-1.5kHz)
CH2
Emergency WA-U(Yelp)
(600Hz~1.5kHz)
CH3
Ambulance PI-PO(Hi-low)
(450Hz~900Hz)
CH4
Pi ik Pi ik(820Hz)
CH5
Machinery Fault(1kHz)
WP
5 Special
Warning
Sounds
(1st Group)
CH1 Fire.A-ANG(560Hz~1.5kHz)
CH2
Abandon Alarm(820Hz)
CH3
Pi ik Pi ik(820Hz)
CH4
High Expansion(1kHz)
CH5 7 Short PI. / 1 Long(1kHz)
WM
5 Melodies
CH1
Sweet Home
CH2
For Elise
CH3
Cuckoo's Waltz
CH4
Piano Sonata
CH5
Turkish March
WA
5 Alarms
CH1
Beep Intermittent
CH2
Door Chime
CH3
Phone Ring
CH4
PI.PI.PI Short
CH5
Tripping Beat
8
Sound pattern & combination
1. Multi functional product has 30 pre-recorded sound tones.
2. 30 sound tones in binary input mode supported. Bit input
mode has 5 sound tones within 1 group among 6 groups.
PLAY MODE
SELECTION
(Regardless of
direction)
1mm
7. PLAY MODE setting switch is used to choose the channel
input method or select various play modes.
•
Rotate each space when choose PLAY MODE by using a
flat-head screwdriver regardless of direction.
8. Refer to the table below for switch features.
*Switch #0 and #9 are not used.
PLAY MODE SETUP
SWITCH
8
Test Mode
In test mode, Ch1 of group is
automatically played back
repeatedly.
To end the test mode, switch
back to the other modes.
