3
Parts Definition/ Bracket Adjustment
■
Parts Definition
• In case angle adjustment is needed after installation, please loosen the
fixing bolt of two brackets
①
completely and remove them.
• Securing the bracket bushings
②
using spanner, loosen the bracket
fixing nuts
③
slightly and adjust the angle as desired.
• Once the angle is adjusted as desired, please secure the bracket fixing
bolt
①
aligning with guide rail and tighten the bracket fixing nut
③.
• M12 connector type product with a cable entry is available
upon request.
■
Bracket Adjustment
■
M12 Connector Type Model
Lens(Tempered glass)
Housing(AI)
Bracket(SPC-1)
M12 Connector
①
②
③
VIEW “A”
VIEW “A”
Installation Environment and Protection Rating
•
This product is designed for use with protection rating of IP67/IP69K.
•
If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indicated(IP67/IP69K), it may cause malfunction or damage to the product.
•
For further information, please visit our website(www.qlight.com).
Installation/ Mounting Hole Specifications
MODEL
QMFLN - 200
QMFLN - 300
QMFLN - 400
QMFLN - 500
QMFLN - 600
A
210
310
420
520
620
4-Ø7 HOLES
20
A
• First, machine taps or holes on the mounting surface
①
.
• The mounting hole of this product is 7mm in diameter(long hole).
• When machining taps, fasten the bolt through the mounting hole of the product.
• When machining holes, insert the bolt through the hole of the product,
and tighten the nut from the opposite side of the mounting surface.
• Install flat washer and spring washer when fastening bolt and nut.
•
Machine holes on the mounting surface referring to the diagram below.
■
I
nstallation
■
Mounting Hole Specifications
①
