Qleen DISY E, User Information

Page: 20 / 36

20 |
For cleaning solution operation, the dosing pump must first be bled, see Page 15 (4.10 Bleeding
the dosing pump) .
When using cleaning solution, observe the respective specifications and safety instructions of
the manufacturer.
5.1 Cleaning with PUREWATER
5.2 Cleaning with tap water and cleaning solution
In the case of heavy soiling, it is cheaper and more effective to pre-clean with tap water first.
The dosing pump mixes the aspirated cleaning solution with the tap water.
The dosing pump has an adjustable flow rate of 1 to 6 liters per hour.
In the case of the Vario brush bow, approximately 200 liters per hour flow through the nozzles, which
corresponds to an adjustable mixing ratio of 1:200 to 1:33.
It is possible to change the cleaning mode at any time using the control buttons and the remote control.
For example, after cleaning with cleaning solution, the hose can be rinsed or the area to be cleaned can be
rinsed with tap water.
The tap water or the cleaning solution is pumped through the black hose.
Cleaning with PUREWATER is the most chemical-free and sustainable way of cleaning.
Surfaces dry streak-free and without wiping due to the good salt absorption capacity of the PUREWATER.
The PUREWATER is pumped through the blue hose.
Cleaning
Switching on the PUREWATER
• Briefly press the »PUREWATER« button on the machine or
remote control, the button lights up green green
⇒ After a short time, the PUREWATER comes out of the
nozzles via the blue hose and the ROTAQLEEN starts up
Switching off the PUREWATER
• Briefly press the »PUREWATER« button on the machine or on
the remote control, all buttons light up blue blue
⇒ Stop the PUREWATER and the ROTAQLEEN