AH20 Robot Maintenance Manual
76
Document Version V1.0.1 (09-21-2022)
Figure 5-23 Remove the power module cooling fan
Step 5
Install a new fan assembly, plug in the fan connector, fix the fan cable
with a cable tie. Connect the connector of the new fan assembly to the
connector of the switch fan.
Step 6
Install the connector panel and base side door of the robot as they
are.
This cooling fan is installed in a hanging manner. Hold it
during installation and removal to prevent the fan
assembly from falling into the control cabinet and
damaging other cables.
The control cabinet has a small space, so take care not to