Programming Admin cards:
- Hold the Main-Admin card in front of the lock for 1~2 seconds (green light flashes 3 times), remove the card
Then hold the Admin card to be programmed in front of the lock for 1~2 seconds. (green light flashes 3 times),
hold the Main-Admin card again in front of the lock for 1~2 seconds (green light flashes), remove the card; setup
successfully.
-
Repeat this procedure for all Admin cards that you’d like to program (max. 10 cards).
-
Programming a User card:
- Hold an Admin card in front of the lock for1~2 seconds. (green light flashes 3 times), remove the card
- Then hold the user card to be programmed in front of the lock for 1~2 seconds until green light flashes,
remove the card
-
Repeat this procedure for all user cards that you’d like to program (max. 10 cards).
III. Deprogramming RFID cards with the RFID LOCK
What happens if admin or user cards are lost? The following instructions detail how to deprogramme cards in
order to maintain the security of the locks.
Deprogramming a Main-Admin card:
-
Reset the lock - remove the battery cover, press the reset button until the lock flash 4 times, then release the
button, reset successfully.
Deprogramming individual Admin cards:
- Hold the Main-Admin card in front of the lock for about
5 seconds (green light flashes 3 times), until it flashes red one time, remove the card;
- After that, the Admin card to be deprogrammed is held for approximately 5 seconds in front of the lock (green
light flashes) until it flashes red twice.
- Along with the Admin card, all keycards that were programmed with this Admin card will be deprogrammed
automatically. Keycards that were programmed by other Admin cards will remain valid.
- Repeat this procedure with all Admin cards that you would like to deprogramme.
Deprogramming individual user cards:
- Hold the Admin card that was used to programme the user card to be deprogrammed in front of the lock for
about 5 seconds. The lock first displays a green flashing light, then it flashes red one time, remove the card;
- After that, the user card to be deprogrammed is held for approximately 5 seconds in front of the lock until it
flashes red twice, remove the card
- Repeat this procedure with all user cards that you would like to deprogram.
www.qilocks.com [email protected] +44 (0)20 8906 6881