Qiagen PyroMark Q96 ID, User Manual, Page: 30 / 126

Installation Procedures
4-4 PyroMark Q96 ID User Manual 01/2016
9. At the new site, unpack the instrument and remove the
transport protection block from under the instrument lid.
10. Follow the reinstallation procedures in Section 4.4 for
stand-alone installation or Section 4.5 for network
installation.
4.4 Reinstalling the PyroMark Q96 ID: Stand
alone
When delivered, the PyroMark Q96 ID is configured as a
peer-to-peer network. The operator’s computer acts as the
host and PyroMark Q96 ID as the guest.
Install a stand-alone system as follows:
1.
Identify the cable marked “Cross-connected TP” provided
with the PyroMark Q96 ID. Connect one end of this
cable to the network connector on PyroMark Q96 ID
(“net”).
Note : The “keyboard”, “mouse”, and “monitor”
connectors are for the use of QIAGEN Field Service
Specialists only.
2. Connect the other end of the Ethernet cable to the
network card connector on the operator’s computer.
3. Connect mains power as per Section 4.6.
4.5 Reinstalling the PyroMark Q96 ID:
Network installation
The operator’s computer is configured with a built-in Ethernet
port to connect to the PyroMark Q96 ID and an external USB
adaptor to connect to a Local Area Network (LAN).
The main advantages of connecting the PyroMark Q96 ID to a
LAN are:

Easier access to run data files

Assays can be set up and analyzed on office computers

Data such as SNP entries can be shared between
different users

Access to LAN printing resources