Qiagen PyroMark Q96 ID, User Manual

Page: 31 / 126

Installation Procedures
PyroMark Q96 ID User Manual 01/2016 4-5
Install a LAN system as follows:
1.
Connect one end of the cross-connected Ethernet
network cable provided to the “NET” connector on the
rear panel of the PyroMark Q96 ID.
2. Connect the other end of the network cable to the built-in
LAN outlet on the operator’s computer.
3. Connect the second Ethernet network cable between the
Ethernet USB adaptor of operator’s computer and the
nearest LAN connection point.
4. Connect mains power as per Section 4.6.
5. Start up the operator’s computer and assign a unique IP
address to the second network adapter for communication
with the LAN.
4.6 Connecting mains power
1. Ensure the standby switch on the front of the PyroMark
Q96 ID is in position (press the lower part of the
switch).
2. Connect the mains cable to the inlet on the rear of the
PyroMark Q96 ID. Connect the mains cable to a
grounded mains power outlet. The PyroMark Q96 ID will
automatically adjust to the correct voltage.
4.7 Setting up network properties
4.7.1 Used IP addresses for instrument and computer
The instrument IP address and the host IP address (operator’s
computer) are fixed and do not need to be changed if the
PyroMark Q96 ID is connected to a LAN.

Operator’s computer IP address: 192.168.255.200

PyroMark Q96 ID IP address: 192.168.255.201