QHY16200A
The picture below shows a typical defect column with low CTE or zero CTE. This is a
defect column. You have to use the some defect tools to remove it.
6. How to use the QHYOAG that the camera comes with?
QHYOAG-M and a M54 adapter come with the QHY16200A. By six M3 screws you
can install them.
The prism of the OAG may have a protect film on front surface.
Please remove it
before using.
You can use QHY5L-II-M as the guider. Please pay attention that you may remove the
front part of QHY5L-II-M to get the back focus short enough for this combination of
OAG-M and QHY16200M. If you are using other guider. We are not guarantee the
back focus is suitable for them due to the very short back focus of the QHY16200A.
The thickness of QHYOAG-M is 10mm and the M53 adapter is 3mm. So the totally
back focus addon is 13mm. The QHY16200A back focus is 33.5mm to 34mm. So the
total back focus with QHYOAG-M is 46.5mm to 47mm.
For more information about QHYOAG, you can check
http://www.qhyccd.com/OAG.html
Summary of Contents for QHY16200A
