Kidgoo 2019
Subject to change. – 06|2019 –
23
Utilisation
Adjusting the buggy wheel
You must make the following settings, depending on the mode.
Removing the buggy wheel (Trailer mode)
The buggy wheel must not be fitted in Trailer mode, because in certain riding situations it can make
contact and cause serious accidents.
f
Slightly lift the cabin at the front.
f
Push the release button at the wheel mount and remove the buggy wheel completely.
Tip!
Carry the buggy wheel e.g. in the storage space in order to allow you to use the
Kidgoo
flex-
ibly at your destination. Instructions for re-mounting it can be found in the chapter
ing the buggy wheel“ on page 16
Setting the wheel so that it turns freely (Buggy mode)
It must be possible for the wheel to move freely through 360° in order to manoeuvre in Buggy mode.
f
Push up the mode switch to release the wheel.
Securing the wheel (Walker mode)
In Walker mode, the wheel must not be at an angle to the direction of travel. You must lock the wheel to
run straight ahead in order to prevent abrupt blocking.
f
Push down the mode switch to make sure the wheel is running straight.
f
Turn the positioned wheel backwards until it engages audibly.
Insert tow bar
The tow bar can either be brought forward into the attachment position or carried along backwards in
the standby position. Pay attention also to the instructions in the chapter
Danger!
Wrap the retaining strap of the tow bar around the tow bar several times to ensure it does
not hang down in the standby position. Otherwise it could become trapped on obstacles.
Using the pennant
The pennant must be attached in Trailer mode, see
„Inserting the pennant“ on page 15
. For safety
reasons, we also recommend this for the other modes.
Attaching the hand strap
In Buggy and Walker mode, the hand strap secured to the push handle must be attached to your wrist
during every journey.
Putting on the 5-point safety harness
In every mode, the 5-point safety harnesses must be properly adjusted and every child must be fastened
in, see
