16
– 06|2019 – Subject to change.
Kidgoo 2019
f
Using the connecting piece, insert the pennant staff into
the extension rod.
f
Insert the extended pennant pole through the loop on the
left head protector and secure the position by inserting
the pennant pole into the recess on the left leaf suspen-
sion cover.
f
Unroll the pennant so that it can fly clearly visible on the
pennant staff.
Optional assembly steps
Installing the buggy wheel
You need the buggy wheel for Buggy and Walker mode. The buggy wheel is connected directly with the
wheel suspension attached to the frame and is mounted so that it can rotate through 360°.
f
Lift the cabin at the front.
f
Place the buggy wheel into the wheel mount as far as it
will go, until it engages audibly with a clicking noise.
f
Check whether there is sufficient air in the buggy wheel
(maximum air pressure: 1.9 bar). If necessary, use an air
pump for car valves to top up with air.
Adjusting the buggy wheel
f
Set with the release button (unlock key)
[A]
and the mode
selector switch
[B]
in front of the suspension the desired
operating mode:
–
Buggy mode: Buggy wheel rotatable through 360 °.
–
Walker mode: Buggy wheel running straight.
–
Trailer mode: unfasten and pull out the buggy wheel.
Mounting the tow bar
You only require the tow bar in Trailer mode. It is used to hook up the
Kidgoo
behind a bicycle equipped
with a suitable coupler, see
„Connecting the trailer to a bicycle“ on page 28
.
The tow bar is attached to the tow bar mount using a locking bolt and can be used in two different
positions:
Attachment position: The tow bar is facing forwards.
Standby position: The tow bar is facing to the rear and is carried under the cabin floor.
In both positions, the tow bar is also secured with a cotter pin.
f
Pull the locking knob with one hand and hold it in place.
f
Push the front button on the tow bar with the other hand
so that the locking bolt unlocks.
f
Keep on pushing down the button and push the tow bar
forwards until the mark in the tow bar mount is reached.
Assembly
