- 5 -
FUNCTIONAL DESCRIPTION AND OPERATION
Attach the saw to the stand. Make sure the stand is level.
A. STARTING AND STOPPING
1. Connect the unit to a power supply of the correct voltage and frequency (120V~, 60HZ).
2. To start the machine press the switch “ON” position.
3. To stop the machine, press the switch “OFF” position
WARNING: FOR YOUR OWN SAFETY, ALWAYS PUSH THE
SWITCH TO THE OFF POSITION (DOWN) WHEN THE
TOOL IS NOT IN USE. IN THE EVENT OF A POWER
FAILURE, BLOWN FUSE
OR TRIPPED CIRCUIT
BREAKER, TURN SWITCH TO THE OFF
POSITION (DOWN) AND REMOVE THE
KEY. THIS WILL PREVENT THE TOOL FROM
STARTING UP AGAIN WHEN THE POWER
COMES BACK ON.
FIG. 3
FIG. 5
FIG. 6-2
FIG. 7-1
FIG. 7-2
FIG. 6-3
FIG. 7-3
B. INSTALLATION Read the
manual carefully before
installation
1. Clean the working area.
Take the machine out of
the carton (FIG. 4).
2. Raise up the side
without wheels by holding
the handle, pull legs out.
(FIG. 5)
3. Unscrew the stand lock
knob, put down the stand.
(FIG. 6-1, FIG. 6-2)
4. Raise the side with
wheel by holding handle.
(FIG. 6-3) Pull out the legs.
5. Reverse procedures
1 to 5 to fold the machine
for packing.
6. ADJUSTING THE
WHEELS
A. For long distance
moves, after folding the
legs, pull out the upper
wheel (FIG. 7-1, 2, 3)
B. While the machine is in
use, make sure the wheels
are up to the locked
position. (FIG. 8-1)
C. For short distance
moves, lock wheels to the
down position lift the
machine and pull by
the handle.
(FIG. 8-3 and FIG. 8-4)
7. One leg is adjustable to
provide firm footing on
uneven surfaces (FIG. 9).
WARNING: SECURE THE MOTOR UNIT WITH THE LOCKING KNOB BEFORE
MOVING THE SAW OR PERFORMING ANY MAINTENANCE!
FIG. 6-1
FIG. 4
