Qeedji SBL10e m365 room, User Manual

Page: 12 / 58

12
Depending on these modes, the
Smart Busy Light
applications can fall into one of these preprogrammed flashing sequences:
Mode
Smart Busy
light
behaviour
Information
Recovery
2 very short and
consecutive blue
flashs (250 ms)
with a 4,5
seconds
periodicity
The Smart Busy Light application can not be executed (it should never occur). The device Web user
interface is so not available. This sequence is displayed until a new firmware update is realized with
Qether
tool. For further information, contact support@qeedji.tech .
Recovery
3 very short and
consecutive blue
flashs (250 ms)
with a 5 seconds
periodicity
The software resource of the SBL10e device set at factory are not valid. It should never occur. For further
information, contact support@qeedji.tech .
Nominal
or
recovery
4 very short and
consecutive blue
flashs (250 ms)
with a 5,5
seconds
periodicity
A SBL10e device
Firmware update
is in progress. Please wait a couple of seconds.
Nominal
5 very short and
consecutive blue
flashs (150 ms)
A SBL10e device
configuration
is in progress. Please wait a couple of seconds.
Nominal
6 very short and
consecutive blue
flashs (150 ms)
The datasource is not consistent because some of the parameters are missing or the Date and time is not
correct because the NTP server is not activated or not valid. For further information about the datasource
form, refer to the chapter § Configuration > Servers . For further information about the reporting of the
problems faced with some datasource parameters, refer to the chapter § Maintenance > Logs .