Qeedji NAPOE109kt, User Manual, Page: 16 / 28

16
1.8 Device fixture
Wall flush-mounted box features and installation
☛ The hole allowing to host the wall flush-mounted box must be done with an hole saw having the appropriate diameter. Then the wall flush-
mounted box has to be fixed in the hole by a qualified person.
◬
To know the TAB10s device fixture height, refer to the legislation in force in your country, related to the accessibility to disabled persons of
establishments open to the public during their construction and of facilities open to the public during their development.
☛ The legislation in force in France implies to install the top of the display at 130 cm (or 51,1811 ") maximum far from the floor. Remove 9.2 cm (or
3.543 ") to this height to determine the height of the hole center to insert the wall flush-mounted box. For example, for the France country, the
hole center should be drilled at (130 - 9.2) = 120.8 cm (47,24 ") far from the floor.
☛ The wall flush-mounted box must have a sufficient volume to host the NAPOE109kt device. The distance
1
between the screws must be 60 mm
(2.362 ").
☛ The wall flush-mounted box type is depending on the wall material. Consequently it is not provided in the packing box.
☛ It is common for the hole saw diameter to be 68 mm (2.67") to make the hole for your flush mount box. However, to confirm the actual drilling
diameter, refer to the drilling requirements of your flush mount box.
◬
It is recommended to install the wall flush-mounted box with the following orientation, with its clamping claws up
2
and down
3
. Then
the NAPOE109kt device with be tightened with the left screw
4
and the right screw
5
.