PROGRAMMING THE DEVICE BY SOFTWARE
FACILE QA-TEMP
It is possible to use the program without connecting
to the module, in this mode you can SAVE the
configuration on your PC, which can then be sent to
the QA-TEMP at a later time.
SERIAL PORTS AVAILABLE:
Check the available COM ports, press the UPDATE
button. Your PC will assign a virtual COM connection
with the QA-TEMP. Press START CONNECTION WITH
THE DEVICE. It will confirm you the connection was
successful with the module. If the connection does not
happen, please check the RS485 serial connection (A
+, B-), the position of the dip-switches (switching off
and on the device) and the COM generated
automatically by the device.
After connecting, you can proceed with the
configuration of the device.
ANALOG INPUT:
you will find the pull-down menu where you can select
the type of input signal: POTENTIOMETERS,
RESISTANCE at 400ohm or 4kohm at 2,3,4 wires, Ni100,
PT100, PT500, PT1000 at 2,3,4 wires, TC type J, K, R, S,
T, B, E, N.
The QA-TEMP sampling data every 100 msec, you can
choose to mediate the input value up to a maximum
of 32 samples.
P
R
O
G
R
AM
M
IN
G
T
H
E
D
E
V
IC
E
B
Y
S
O
F
T
W
AR
E
FA
C
IL
E
Q
A
-T
E
M
P
3
09
2015
The programming of the module QA-TEMP may be performed in two different ways:
·
via the interface program free FACILE QA-TEMP through the microUSB port on the module or via RS485
connection;
·
via the RS485 serial connection (from terminal or T-Bus).
The QA-TEMP has two microprocessors, you can configure the module by connecting it to the USB port of your PC
without the power lead, this is possible because the microprocessor that manages the configuration is powered
directly from the USB port.
To use the program FACILE QA-TEMP, go on our website
www.qeed.it
in the PRODUCTS page, on the right menu,
click on DOWNLOAD SOFTWARE and then click FACILE QA-TEMP, you can install the program on your PC. Once
downloaded, install it in the desired directory and run the program.
ENGLISH
