Well Wizard®
Installation and Operation Manual
Rev. E 06-05-2023
1
Safety Warnings
Wear appropriate Personal Protective Equipment (PPE) including safety glasses when working with QED sampling
pumps. Disconnect air supply to the pump before removing the pump from the well. Do not apply more than 5 psi air
pressure to the pump if the pump is above ground.
Contacting QED
Please call our Customer Service Department at one of the following numbers for
assistance
•
Monday through Friday, 8:30 a.m. to 5:00 p.m. Eastern Time: 800-624-2026
or +1-734-995-2547
•
After Hours and weekends:
1-800-272-9559 or +1-734-746-8045
Introduction
The Well Wizard dedicated bladder pump system includes both dedicated down-well components
and portable above ground components. The water contacting components are dedicated; they
remain installed in each well. The pump controller, compressed air or gas source and water
quality monitoring components are portable and are transported from well to well.
This document is intended to assist you with the proper installation of your Well Wizard dedicated
bladder pump system, covering key steps and installation tips. Your system may have some
custom components that may require some deviation from these instructions. Instructions for
those components will typically be included on an accompanying separate instruction sheet.
If you have any questions or problems while you’re in the field and can’t find a solution, please
call QED Customer Service at the phone numbers above. For questions that aren’t urgent, you
can send an email to us at
.
Dedicated System Components (Well Wizard Type A systems)
•
Bladder pump
•
Inlet screen
•
Twin-Bonded pump tubing
•
Well cap
•
Discharge adapter
OPTIONAL SYSTEM COMPONENTS
•
Drop tube inlet kits (Well Wizard Type L systems)
•
Freeze Protection (recommended in cold climates)
•
Support cable
