12
13
Installation In Between Two Spindles
Step 1
Carefully loosen
the screws on the
two Long Mounting
Brackets by using a
Phillips screwdriver
until it allows
the width to be
adjusted.
Adjust the width of the two Long
Mounting Brackets outward until the
angled stops fit tightly on the inside in
between the two spindles.
Tighten the screws.
Step 2
Use the included Socket Screws and
connect the two Wood Boards to
create one long board. Make sure the
wood block is in place.
Step 3
Hold one of the Long Mounting
Brackets and the long wood board
up to the spindles. Position the top
Bracket about 2
″
(5 cm) below the
handrail on the “lower
″
spindle and
the bottom Bracket 2-4
″
(5-10 cm)
above the stair. Mark the Mounting
Bracket locations on the “backside
″
of
the long wood board.
Step 4
Thread the
Mounting Strap
through the Long
Mounting Bracket
with smooth side of
the Mounting Strap
towards the nut
that holds the Long
Mounting Bracket
together.
Step 5
Attach the two Long Mounting
Brackets to the back of the long
wood board in the marked locations,
using the four wood screws.
Step 6
Hold the long wood board with
the Long Mounting Brackets up to
the spindles with the wood facing
the gate location and wrap the top
Tightening Strap around the two
spindles. Feed the end through the
small hole in the Tightening End.
Pull on the strap and attach the
