Manual for ZillioX 5
Enable keyboard password power-on function (JP2)
The motherboard provides the advanced keyboard password power-on function. When
wanting to use this function, set JP2 with pin1& pin2 closed. Otherwise, set JP2 with pin2 & pin3
closed for disabling this function.
In order to implement this function, set “ POWER ON Function” to Password and enter the
keyboard power-on password in the “ INTEGRATED PERIPHERALS” section of the BIOS.
Save and exit, then power off your system. In this case, the power button’ s power-on
function has been disabled. The only way to power up the system is to enter the correct
password. If you forget the password, clear CMOS and set it again. Refer to BIOS descrip-
tion on page 46 for detail information.
Note: 1.If wanting to use this function, 5VSB line of the power supply should be
capable of delivering 200mA, or the system can’t be powered up.
2.If you set JP2 with pin2 & pin3 closed, set “POWER ON Function” to
BUTTON ONLY, don’t set it to Password, or this will prevent you from
powering up your system.
3. If you encounter problems above, clear CMOS and set the jumper and
BIOS option properly again.
Speaker/Line out selection ( JP10, JP11)
If you want to set the Line-out/Speaker-out jack as Line out, set JP10 & JP11 with pin2&pin3
closed. Otherwise, set JP10 & JP11 with pin1& pin2 closed for Speaker out.
Disable
Enable
JP2
JP2
Installation Instruction
26
Set as Line-out
Set as Speaker-out
JP10
JP11
JP10
JP11
3 2 1
1
3 2 1
1
