Installation Instructions
P5I848P
14
Wake-Up On Internal Modem (WOM)
Through this function, the system which is in the suspend or soft-off status can be
waked up by a ring signal received from the internal modem. When this function is
used, be sure an internal modem card which supports this function is used. Then
connect this header to the relevant connector on the modem card, set “Power on by
Ring/LAN” as Enabled in the “Power Management Setup” section of the CMOS
SETUP. Save and exit, then boot the operating system once to make sure this func-
tion takes effect.
WOM
Signal for waking up(active low)
+5V standby
GND
1
Serial Port Connector(COM2)(optional)
The serial port COM2 is not available on the back panel. Therefore, we provide a 9-pin
header.
COM2(optional)
DCD
GND
SOUT-
RTS
RI
SIN
NC
DSR
CTS
DTR
