Manual for KinetiZ 7E/KinetiZ 7E-A/KinetiZ 7E-C
Wake-Up On Internal Modem (WOM)
Through the Wake-Up On Internal Modem function, the system which is in the power-off
status can be powered on by a ring signal received from the internal modem. If this function
is to be used, be sure an internal modem card which supports the function is used. Then
connect this header to the relevant connector on the modem card, set “Modem Ring Resume” as
Enabled in the “POWER MANAGEMENT SETUP” section of the BIOS. Save & exit, then boot
the operating system once to make sure this function takes effect.
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 2.01 power
supply of which 5VSB line is capable of delivering 720mA, and a LAN adapter which
supports this function are used. Then connect this header to the relevant connector on the
LAN adapter, set “Modem Ring Resume” as Enabled in the “POWER MANAGEMENT SETUP”
section of the BIOS. Save & exit, then boot the operating system once to make sure this
function takes effect.
Infrared Header (IrDA)
This connector supports wireless transmitting and receiving. If using this function, set
“UART 2 Mode” to HPSIR or ASKIR and configure the settings from the “INTEGRATED
PERIPHERALS” section of the BIOS.
Installation Instruction
1
1
+5V standby
GND
Signal for waking up (active low)
+5V standby
GND
Signal for waking up (active high)
VCC
NC
IRRX
GND
IRTX
VCC