Manual for Advance 10TM
ATX Power Supply Connector & Power Switch( POWER SW)
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch ( POWER SW) should be connected to a momentary switch (power button).
When powering up your system, first turn on the mechanical switch of the power supply (if
one is provided), then push once the power button. When powering off the system, you
needn’t turn off the mechanical switch, just
Push once
*
the power button.
Note: * If you change “soft-off by PWRBTN” from default “Instant-off” to “Delay 4
Sec” in the “POWER MANAGEMENT SETUP” section of the BIOS, the power button
should be pressed for more than 4 seconds before the system powers down.
Hard Disk LED Connector (HD_LED)
The connector connects to the case’s IDE indicator LED indicating the activity status of IDE
hard disk. The connector has an orientation. If one way doesn’t work, try the other way.
Reset Switch (RESET)
The connector connects to the case’s reset switch. Press the switch once, the system
resets.
Speaker Connector (SPEAKER)
The connector can be connected to the speaker on the case.
Chapter 2
ATX Power Supply Connector
POWER SW
20
1
5V
5 V
-5V
GND
GND
PS-ON
-12V
3.3V
GND
12V
5VSB
5V
GND
3.3V
GND
5V
GND
PS-OK
3.3V
GND
