15
INSTaLLaTIoN aND oPeraTIoN MaNUaL SoLar MoDULeS GeNeraTIoN 3 (G3) – HaNwHa Q CeLLS GMBH – Na
14
INSTaLLaTIoN aND oPeraTIoN MaNUaL SoLar MoDULeS GeNeraTIoN 3 (G3) – HaNwHa Q CeLLS GMBH – Na
DANGER
! Risk of fatal injury due to electric shock!
Ä
Block off the installation zone.
Ä
Keep children and unauthorized individuals away
from the solar power system.
DANGER
! Risk of fatal injury due to electric shock!
Ä
Ensure that modules and tools are not subject to
moisture or rain at any time during installation.
WARNING
! Risk of injury due to falling modules!
Ä
Secure modules during installation.
Ä
Do not install modules in windy or wet weather.
DANGER
! Risk of fatal injury due to electric shock!
Ä
Only use dry, insulated tools.
Ä
Do not carry out the installation alone.
•
Only install undamaged modules and
components.
Ä
Do not drill any other holes.
3.2 Preparation of installation
3 INSTaLLaTIoN
Ä
Maintain an interval of at least 0.39 in (10 mm)
between two modules along the short side and
0.20 in (5 mm) along the long side.
0.39 in (10mm)
0.20 in
(5 mm)
Option 2:
Ä
Install the module at the 4 mounting points, see
Ä
Tighten screws according to manufacturer’s
instructions.
NOTE
! Module damage may occur!
Ä
Do not subject modules to mechanical tension.
Max. torsion 0.39 in/yd (10 mm/m).
Option 3:
Ä
Install the module using mounting profiles, see fig.
Option 1:
Ä
Fasten the module with 4 clamps in the specified
clamping range, see fig. 3, page 8.
Ä
Tighten clamps according to manufacturer’s
instructions.
3.3 Module installation
3 INSTaLLaTIoN