QCA Spas TheraSauna Classic Series, Owner'S Manual

Page: 15 / 26

13
● ● ●
Digital Control Operating Instructions
Digital Keypad Start Up & Adjustments
Note:
If you experience power failure, sauna will return to factory default settings, which are 135
℉
and 60
minutes, you will have to reset your settings. On powering up the sauna, the panel will display sauna
internal temperature.
Once the TheraSauna® Classic reaches the set temperature, the heat indicator light will turn off to let you
know the sauna has reached your desired temperature. This does not mean that the sauna is no longer
emitting infrared, but that our patented, StableHeat™ system will now kick in. The onboard computer will
reduce the voltage going to the TheraMitters™ to keep them on and emitting infrared, while simultaneously
keeping the pre-set temperature from extreme fluctuations.
Session Timer Adjustment
With sauna in the “Off Mode” (orange heater light off) repeatedly press time button until desired session
time is reached.
Setting Temperature
With sauna in the “On Mode” (orange heater light on) repeatedly press temperature up/down button until
desired temperature is reached.
•
When heater/light on/off button is pressed, the interior and exterior sauna lights will turn on. The
sauna light may be turned on or off at any time in any mode by pressing light on/off button.
•
Normal operating temperature is 100
℉
- 140
℉
(37.8
℃
- 140
℃
).
Diagnostic Codes
SN: Bad temperature sensor, replace temperature sensors.
OH: Overheat, allow sauna to cool down. No service is needed.