Jewel +3 Series Spas
Initial Start-up
When your spa is first powered up, it will automatically heat and maintain 100
°
F until you change the set
temperature. In the event of a power failure or during a manual shutdown, the spa will revert to the last set
temperature, mode, and filter cycle before the loss of power once power is restored.
Self Diagnosis/Priming mode of spa takes six minutes. Four minutes after power-up "- -" will appear for two
minutes. Spa is now ready to program.
DO NOT DISTURB
during the six-minute self-diagnostic procedure.
SECOND WATER PUMP IS OPTIONAL
Icon Legend
Heat Icon - Indicates different
stages of heating.
f
n bright.
Jets Icon - Spins fast on high-speed
spins slow on low speed.
Blower Icon - Biggest in
highest speed; smallest in
lowest speed.
Fiber-Optic Light Icon – Spins when
the wheel is on; stands still when
wheel is off.
Light Icon - On dim, the
LCD will show the center
circle plus one quarter of the light beams. Half o
the light beams will show on medium brightness,
and all of the light beams will show o
Temp Set
(80°F - 104°F / 26.0°C - 40.0°C)
The start-up temperature is set at 100°F/37.5°C.
The last measured temperature is constantly
displayed on the LCD.
Press the “Warm” or “Cool” button once to display
the set temperature. Each time either button is
pressed again, the set temperature will increase or
decrease depending on which button is pressed.
After three seconds, the LCD will automatically
display the last measured spa temperature.
Note that the last measured spa temperature
displayed is current only when the pump has been
running for at least 2 minutes.
Setting the Time
When time hasn’t been programmed, the TIME
icon flashes.
Press Time and then the Mode/Prog button.
Select the hour by pressing the warm or cool
arrows. Each press changes the time by 1 hour.
Select minutes by pressing the Mode/Prog once
again followed by the warm or cool arrows. Each
press changes the time by 1 minute.
Press the Mode/Prog to exit the time setting
procedure and enter the optional filter cycle
programming.
Mode/Prog
This button is used to switch between standard,
economy, and sleep modes. Press “Mode/Prog” to
enter mode programming, press “Cool” to cycle
through to desired mode (LCD flashes until
confirmed), then press “Mode/Prog” to confirm
selection.
Standard mode
maintains the desired
temperature. The “STANDARD” icon will display
until the mode is changed.
Economy mode
heats the spa to set temperature
only during filter cycles. The “ECONOMY” icon
will display until mode is changed.
Pressing “Jets 1” while in Economy mode puts the
spa in Standard-In-Economy mode, which operates
the same as Standard Mode, then reverts to
Economy Mode automatically after 1 hour.
During this time, a press of the “Mode/Prog”
button will revert to Economy Mode immediately.
Sleep mode
heats the spa to within 20°F (11°C) of
the set temperature only during filter cycles. The
“SLEEP” icon will display until mode is changed.
5
