8
HC200 Conveyors | Installation & Maintenance Instructions
Maintenance
Care and Cleaning
u
General Recommended Cleaning Steps
1
Lock out power per your facil-
ity’s procedure and remove
belt, tail end and drive end. (Refer
to belt removal section of this
manual)
2
Clear conveyor of any large
particles. (Wipe with cloth or
scrape with plastic scraper)
3
Pre-rinse conveyor.
4
Scrub conveyor with your
facility’s specified cleaning
solution.
5
Rinse off conveyor.
6
Check to ensure conveyor is
free of dirt. (Repeat steps 3-5
if needed)
7
Apply sanitizer per your facil-
ity’s specifications.
8
If sanitizer is not allowed to
dry, rinse off conveyor.
>
Re-install Tail End and Drive End using steps on the following page.
>
Re-install belt using steps in the belt change section of this manual.
*
Due to the diversity of materials and applications, the information given on this page represents only a general guideline. The cleaning process should be individually
optimized to follow your facility’s guidelines and standards. QC Conveyors recommends following chemical manufacturers specifications, limitations and recommendations in
regards to dry time, materials the solution can be applied to and method of application.
