2
INSTALLATION
Installation the bulkhead light, please referring to the Fig.2
1. Installation by a licensed electrician and according to IEC wiring
Regulation.
2. Switch power off at the meter box and ensure that there is no
power to the lamp.
3
．
Ensure install the unit according to the indicator of symbol direc
-
tion on cover (
UP)
4. Remove the Lampshade by Screwdriver, see figure.
5. Unscrew the Screw (A) and remove the Transparent Plate.
6. Mark the mounting hole positions onto the wall. Drill and plug the
wall at the marked positions. Screw the lamp body to wall with
suitable Mounting Screws (supplied)
7. Connecting the main power wires to the Terminal Block (see the
relative symbols—Fig.2), the Cable must pass through the Wiring
Rubber Gasket.
8. Insert the Max. 60Watt / 230V~ 50Hz incandescent Bulb into the
Lamp-holder (E27)
9. Re-screw Transparent Plate.
10. Re-fit the Lampshade by hand.
11. After finish the mounting, you can adjust the detection area and
working state of PIR Sensor.
L N
Fig. 2 Mounting and Wiring to Treminal
Screwdriver
Transparent
Plate
Terminal Block
Bulb
Mounting Scerws
(2PCS)
Screw (A)
Lampshade
UP
118 mm
256 mm 114 mm