Q.VITEC ANPVC 1210D, Manual

Page: 21 / 28

Table of contents
21
If you would like to use the partial scan mode, the camera needs to be programmed via the
serial interface. Please contact the technical support.
Time diagram for image grabbing
Important: The duration of the image grabbing depends to a large degree
on the image transfer time and the shutter speed:
image grabbing = shutter speed + image transfer time
All camera settings like shutter speed, offset, gain, gamma, flash signal output etc. are made
on the property page "Camera Settings" under
Camera  Properties in the software. For
example, it is possible to set a delay between the camera trigger and the flash signal output
so that you can set the optimum exposure time and duration for the image grabbing. This will
help to reduce the interfering effect of other light sources and increase the service life of your
flash. Make sure to activate the output of the flash signal with the option "Send flash signal".
Example for flash signal and camera trigger
Please also refer to the information supplied by the manufacturer of your
flash!