82
83
ALARM OUT
Set how the alarms are handled and transmitted in this window. This controls any device
attached to the ALARM OUT port on the back of the DVR. There are three tabs;
Alarm Out
,
Schedule
and
Buzzer
.
Alarm Out Tab
You can set the relay alarm out name as well as the hold time. Hold time is the interval
between consecutive alarm activations so multiple events within the interval will not cause the
alarm to sound again.
Schedule Tab
The default setting is for the ALARM OUT to be active all the time, but this can be changed
to meet your particular requirements in a similar manner to
Schedule
in
SECTION 4.4
.
Buzzer Tab
As with the
Alarm Out
hold time, the internal buzzer can be enabled and given a hold time.
PICTURE 8-13
HARD DISK DRIVE
CHAPTER 9
Your DVR uses a standard desktop or 3.5” SATA (Serial Advanced Technology Attachment)
hard disk drive and will support drives up to 2TB (terabytes). These drives are the current
industry standard and may be purchased wherever computer parts are sold. Depending on
where you purchased your DVR, your hard drive may already be installed. But, we recognize
that you may wish to upgrade or replace your drive in the future so this DVR is designed to
make installation and replacement easy for the average user. A 5400RPM drive will work but a
7200RPM drive is recommended for optimal performance.
It should be noted that while this is the only user-serviceable part within the case besides the
battery and you will not void your warranty by installing or upgrading your hard disk drive, care
must be taken to avoid damage to the other components within the case. Such damage will
not be covered.
VGA
SPOT
DC 12V
VIDEO OUT
VIDEO IN
1
3
5
7
9
11
13
15
2
4
6
8
10
12
14
16
USB
NET
ALARM OUT
P/Z
Y
Z
A
1
3
5
7
9 11 13 15
2
4
6
8
10 12 14 16
B
RS485
ALARM OUT
ALARM IN
1
2
3
4
K/B
GND
COM
NO
SV
Remove Screws
9.1 INSTALLATION/REMOVAL
It is strongly advised against opening the case when atmospheric conditions present the risk
of static discharge which can damage electronic components.
Whether installing the drive for the first time or removing the old one to install a new one, the
steps are largely the same:
STEP 1
. Disconnect the DVR from the power source as well as any other connections.
STEP 2
. Remove screws (the number will vary depending on your model) from the side
and rear of your DVR as indicated in
Picture 9-1
PICTURE 9-1
PICTURE 9-2
STEP 3
. Remove the case by sliding it
backwards and then lifting off.
STEP 3A
. If removing a hard drive, you
will need to unscrew the four drive
mounting screws at the bottom of the
DVR or on the internal mounting rack.
Holes for
Hard Disk Drive
Mounting Screws
Holes for
Hard Disk Drive
Mounting Screws
WARNING! ELECTRIC SHOCK RISK!
The DVR
MUST
be unplugged from all power sources as well as from
the cameras before opening the case. Failure to do so can result in
damage to the DVR or its components as well as injury or death.
