INSERT OR REMOVE
INSTRUMENT
OPERATION
CLEANING & CARE
I N S T R U M E N T S
STEP 3:
Insert or remove the
instrument as needed.
STEP 4:
Release the collar and it will
snap back into position.
STEP 1:
Grasp ACMI Quick Disconnect
Collar between Thumb and fore fi nger
as shown.
STEP 2:
Pull collar back toward the black
handle of the instrument adapter. It will
only move about 3 mm.
PULL BACK
The fi ber optic light transmitting surfaces
on both ends of the fi ber optic clip or wand
should be wiped clean with isopropyl alcohol
before autoclaving or chemiclaving.
In the event that a fi ber optic clip becomes
loose,
gentle
pressure can be applied with
pliers to tighten clips.
STERILIZATION
Your fi ber optic instrument may be autoclaved
or chemiclaved. Do not exceed 275°F (135 C).
Please note that exposure to heat will reduce
the life of your fi ber optic instrument. The
average life expectancy of fi ber optics is 18 to
24 months with autoclaving or chemiclaving.
This time could be longer or shorter
depending on frequency and temperature of
autoclave or chemiclave.
DO NOT attempt to sterilize the
Instrument Cable or Battery Pack.
See reverse side for cleaning and care
of instrument cable and battery pack.
On/Off button:
Turn on & off,
Comes on at last used
intensity setting
Increase intensity button:
10 positions, beeps when
pressed, long beep at
maximum intensity
Decrease intensity button:
10 positions, beeps when
pressed, long beep at
minimum intensity
Low Battery Warning:
5 short beeps, every 60
seconds, starts with about 7
minutes life remaining
Use circular motion
Connect instrument
adapter cable to
battery pack and
enjoy your Q-Optics
Radiant
™
Light System.
