QLH-.6510SE/DE
QLT-.6510SE
Thanks for choosing Q-Logic! - Quite possibly the most advanced loudspeaker
enclosure available for Mobile Electronics and the ONLY subwoofer enclosure with
the
new & improved
Q
x
e
-
Ring (patent-pending), a multi-diameter woofer mounting adapter that can extract
optimum performance from any driver you choose! Follow the instructions to custom fit your driver to the enclosure.
YOUR INSTALLATION CAN MAKE A HUGE DIFFERENCE IN THE SOUND QUALITY!
TM
A. If your driver has a mounting diameter of 9.25" or less you are ready to hookup and
install the driver. However, if you have one of the monster cast baskets with a mounting
diameter greater than 9.25", check out the section on the back for additional instructions
before contuning.
Step 1: Set up
Step 2: Installing the Driver.
B. Hook up the speaker lead provided with the enclosure to the driver. Be sure to wire the
positive to red and the negative to black.
D. Using the supplied screws, securely mount the driver in the enclosure. It is
recommended to start all screws and then come back and retighten screws to
prevent the driver basket from being bent or distorted during mounting.
C. Center the frame of the driver within the rings in the Qxe - Ring. Use the location
marks on the Qxe - Ring as guides to align the driver mounting holes. Confirm the
driver is still centered within the rings.
A. Install the grill by locating the mating features on the Qxe Ring with those on the outer
edge of the grill. (See illustration.)
Step 4: Secure the Enclosure.
Flying speakers can be
DANGEROUS ! ! ! It is recommended that you securely mount
your Q-Logic enclosure to prevent it from moving. If you do not wish to permenantly
mount the enclosure there are a variety of brackets available at most hardware stores
that can be used to secure the enclosure and allow for easy removal when neccesary.
Step 3: Reinstalling the Grill.
B. Reinstall the screws securing the grill to the enclosure.
Good luck and enjoy your new subwoofer!
B. Remove the two Phillips screws securing the grill to the enclosure and remove the grill.
Unpack the hardware kit located inside the enclosure. The kit contains mounting screws,
speaker leads, and polyfil batting.
A. Place the enclosure on a solid work surface with the driver mounting hole facing up.
C. Connect the speaker lead to the terminal cup being sure to connect red to positive and
black to negative.
Supplied Hardware:
Mounting screws
Speaker leads
Polyfill
