■ POLE Mounting
ST45L/ST56L-Series
ST80L-Series
Standard
SCREW & NUT 18mm
SCREW & NUT 24mm
L-type bracket
LB18
LB24
Wall Mounting-
type bracket
LW18
LW24
round type bracket SZ18
SZ24
bendable round
type bracket
SL18
SL24
* Please refer to below 6 Wiring Instruction-2 for the detail of bracket.
There are 4 main methods of Tower Lamp installation in
accordance with the locational condition or purpose of the
installation. By referring to the followings, select the method of
installation corresponding to the product.
Style
Size
18mm
SCREW & NUT
(standard)
Standard types
24mm
SCREW & NUT
(standard)
Standard types
LB18
LB24
LW18
LW24
SZ18
SZ24
SL18
SL24
▪ Please do not connect power line to the signal line of
steady/flashing type. Do use a point of contact without power
line.
▪ When changing lens kit, please do not pull with a strong power.
It can cause a break of lens kit.
▪ When wiring is complete, make sure end of any unused wires
are insulated by tape. A short circuit of signal line can cause a
trouble.
▪ If using voltage is seriously higher or lower than rated voltage,
it can reduce the self-life of the product or can cause a
problem on product operating. Make sure the using voltage
does not /-5% of the rated voltage.
▪ If lens or body of the product is contaminated by chemicals
such as thinner, benzene, the product can be damaged,
discolored or deformed. Please be careful.
▪ Do not strongly pull the wire out from the product. It can
cause a disorder.
Wiring Instruction -2
-
Caution
