Unsetting The Panel
The panel may be unset by entering the building via the entry/exit route and then entering
either the Master Code or any of the Limited User Codes.
Enter
(User Code)
Reset After Alarm Condition
Enter
User code to stop alarm
Enter
User code to reset the system
If the panel will not reset then your installer has enabled engineer or anti code reset, please
contact your installation company.
Duress Set/Unset
Enter
(User Code) Reverse the last two digits of the code.
The panel will then appear normal but a Duress Code will be sent to the Central Receiving
Station.
Personal Attack Alarm (PA)
To Activate the Personal Attack Alarm enter
. Enter a user code to cancel.
Fire Alarm
To Activate the Fire Alarm enter
. Enter a user code to cancel.
Turning Chime On and Off
(Panel must be in ‘day’ mode
Enter
. The status of the chime facility is indicated by the ‘chime’ LED on the front
of the control panel. When the chime mode is selected a two tone chime will be produced by
the internal sounder and any extension speakers when an Entry / Exit zone is activated. The
same key sequence may be used to turn off the chime facility.
Reading The Event Log
Panel must be in ‘day’ mode
Enter
. The ‘day’ led will flash and the most recent event stored in the log will be
displayed.
If the up arrow key
is pressed the previous log entry will be displayed. Similarly if the
down arrow key
is pressed the next most recent entry will be displayed. The event log
may be scrolled backwards and forwards using the up and down arrow keys to allow the last
100 events to be viewed.
To leave this function press the
key.
An error tone will be produced if an attempt is made to scroll outside either end of the event
memory log.
Refer to the table below for the symbols stored in the event log and their meanings.
Symbol
Meaning
o
Activation of a programmable zone.
Keyswitch Activation
This shows that a zone was omitted and refers to the number which precedes it in
the log
Keypress tamper - Four attempts cause a tamper fault.
Keypad Personal attack activation.
Engineer Code Entered.
Keypad Fire alarm activation.
Set A
Set B
Set C
Set D
Unset
System Fault
MASTER ONLY FUNCTIONS
Event Log Reset
Enter:
This feature will only operate if, whilst programming, the engineer selected the feature
allowing the Master User to clear the event log.
4
RINS137-7 RINS137-7
5
Intelligent Security & Fire Ltd
