LEANING, MAINTENANCE & STORAGE 12
_____________________________________________________________
CLEANING AND MAINTENANCE
It is important to perform regular maintenance and safety checks on your fire table. Proper maintenance with extend the
life of the product and its components.
Stainless steel will rust or corrode over time if contamination or debris is not cleaned or removed. When not in use, it is
recommended that the fire table is protected with a canvas cover in order to protect it from weather and debris.
BURNER ASSEMBLY:
The burner must be inspected and cleaned annually. The burner assembly must be replaced prior to the appliance
being put into use if any evidence of damage is found. The replacement burner assembly must be one specified by
Pyromania Inc. in the parts list located on page 15. To inspect and clean the burner pan and ring, follow these steps:
1.
Remove the decorative lava rock and examine the burner. Vacuum and clean it as necessary.
2.
Inspect the burner pan and ring for warping and corrosion. Repair or replace as necessary
3.
Verify that the burner ring holes are not clogged with debris. Clear as necessary.
4.
Clean the burner ring and pan with a soft wire brush
5.
Verify the air shutter is clear of spider webs, insects and debris. Confirm that it is set in the right position for the
fuel type being used (the air shutter is located underneath the burner assembly).
6.
Verify that the stainless steel flex pipes are tight and undamaged. Tighten and/or replace as necessary, then
perform a leak test.
GAS SUPPLY HOSE:
Check the hose assembly for excessive abrasion or wear. The hose assembly must be replaced prior to the appliance
being put into use if any evidence of damage is found. The replacement hose assembly must be one specified by
Pyromania Inc. in the parts list located on page 15.
FIRE TABLE BODY:
For routine cleaning of the fire table, wipe down with a damp cloth or sponge and mild dish soap. Avoid using any
other cleaners as they may contain chemicals that can cause discoloration. To remove stains, use a marble or granite
stain remover available at a local home improvement or masonry supply store. Follow the application instructions
provided by the stain remover manufacturer
The fire table surface was sealed at the factory to help protect against staining. Over time, the sealer will breakdown
and must be re-applied. It is recommended to reseal the surface annually with an outdoor concrete sealer available
at a local home improvement or masonry supply store. Follow the application instructions provided by the sealer
manufacturer.
STORAGE
Storage of the appliance indoors is permissible only if the gas source is disconnected and gas cylinders are removed from
the appliance.
When storing propane cylinders, they must be stored in an outdoor location out of reach of children. Never store tanks
in an enclosed environment, in direct sunlight or near a source of heat or combustion. Propane cylinders should have a
dust cap installed when being stored.
To extend the life of your fire table, protect it from the elements with the supplied weather resistant cover when not in
use. Ensure that the appliance has ample time to cool off after use and prior to installing the cover. Damage to the cover
due to heat or burns are not covered by the warranty.
C
