TIMETRAX™ SYNC RF WIRELESS DIGITAL CLOCK
Installation Instructions (cont.)
WIRED MODELS
WIRING SHOULD BE COMPLETED BY A LICENSED ELECTRICIAN AND IN COMPLIANCE WITH ELECTRICAL CODE.
Install metal security bracket onto a standard electrical box.
Make electrical connections.
This should only be performed by a licensed electrician
.
Push clock onto security bracket aligning four tabs on bracket with four matching slots on back of terminal.
Slide clock downward until locking tab clicks into place. When properly mounted, clock cannot be slid up
and off bracket without using included wall bracket release key to disengage locking tab.
Upon power up, clock will initially display
. Clock will synchronize to the RF Wireless Transmitter
immediately upon receiving a radio signal (typically 1-2 minutes).
I2255
Page 2 of 5
888.479.7264
pyramidtimesystem.com
CORD MODELS
Install metal security bracket onto a standard electrical box, or if not using electrical box, hold security
bracket flush against wall, level & mark four screw holes close to corner tabs. Drill holes as marked and
secure bracket to wall using provided screws and wall anchors.
Feed cord through channel located at bottom of clock.
Hang clock on security bracket (see step 3 above).
Plug clock into standard electrical wall outlet. Upon power up, clock will initially display
. Clock will
synchronize to the RF Wireless Transmitter immediately upon receiving a radio signal (typically 1-2
minutes).
